Un système de contrôle automatique de la qualité du sable fait partie à l’heure actuelle d’une installation moderne de traitement des sables de fonderie.
SPC is an universal measuring system with selective sampling to control the operation of batch mixers
For installation at a conveyor belt transfer point – The standard system SPC II is preferably installed at a conveyor belt transfer point between the mixer and the molding line.
A miniature turntable continuously extracts small amounts of sand from the flowing sand stream and fills a cylindrical test container (Diameter 50 mm, height: 100 mm).
The sand sample will be tested for compactability and optionally for compression or shear strength, moisture content and temperature. The number of test samples per batch can be adjusted based on customer specifications. Based on the measured values, additions of water and bentonite for the next batch can then be corrected. The system consists of only a small number of moving components thereby guaranteeing long life expectancy with low maintenance requirements.
For installation on a mixer with sampling and preparation unit – Here, the standard system SPC II and a sampling and preparation unit is mounted directly on the mixer.
The SPC III solution is suitable for all types of mixers with a fixed mixing drum. To mount the equipment requires an opening in the mixer’s drum wall of approximately 70 mm.
The sand sample is prepared and then dropped into the cylindrical test container. The same measurements can be taken as for the standard system.
For installation at a conveyor belt with mechanical sampling device – This system consists of the standard system equipped with a mechanical device capable of extracting sand samples directly from the conveyor belt.
This mechanical device can be designed in a variety of ways and will be developed with considerations of the customer requirements. This system is also capable of performing the same tests as the standard system.
and Measurement of
– the Compactability
– the Compression Strength (optional)
– the Moisture Content (optional)
– the Temperature (optional)
Un modèle de base avec un certin nombre de modules permet de constituer une installation dans tous les cas de figure.
